Improving unit efficiency
Customer request:
The small-capacity AVT-200 atmospheric-vacuum distillation unit requires revamping to improve its operating efficiency.Spliteks solution:
- Process flow analysis, calculations and coordination of solutions with the customer
- Engineering with maximum use of the existing shells
- Manufacturing at the facility in Serpukhov
- Delivery of the batch to the customer’s site
- Installation supervision at the customer’s site and advice during commissioning
Result
Draw-off of on-spec summer and winter diesel fuel across the entire throughput range using a single internals design.
Other Spliteks solutions
Installation
Customer request:
Manufacturing and supply of column internals for three phases of a stable gas condensate fractionation and transshipment complex at the port. Urgent supply and installation of column internals for the damaged main fractionator of Phase 2
Integrated solution
Customer request:
Upgrading deethaniser 2/ZOK-1 to increase its capacity by 20% above the design capacity while ensuring that the total mass fraction of methane and ethane in the deethanised condensate does not exceed 0.8%:
Replacement of obsolete equipment (column internals) dating from 1975
Customer request:
Obsolete equipment (column internals) dating from 1975 must be replaced.
Increasing product draw-offs
Customer request:
Increasing the draw-off of the fourth vacuum side cut from column K-5 of the CDU/VDU-6 unit and improving its quality (reducing the colorimeter colour reading) while increasing the tar viscosity to approximately 300 mm²/s or higher,
Improving fractionation sharpness and optimising operation of the wash section in vacuum column K-5 of the CDU/VDU-6 unit.
Show more
Do you have any questions?
We will provide a consultation, calculate the cost and answer all your questions